Wind protection roller blind Height 2.10 m Width 3.50 m

1) Steel profile tubes
All roller blinds are supplied with a tube diameter of 100 mm.

2) Determining the dimensions
The width and height of the ordered pull-up blind indicate the dimensions of the actual net. The tubes are 100 mm longer than the net width (50 mm on each side). The spring mechanism is always on the left-hand side of pull-up roller blinds. The clearance height is reduced by 100 mm.

3) Fitting
Pull-down blind: minimum width: 2.35 m
The height does not need to be adjusted on site (excess net remains wound onto the tube). The width must be adjusted.

4) Bottom end lip
Floor end lips with heights of 14 cm, 34 cm and 51 cm are available

5) Blocking mechanism
All wind protection roller blinds have a blocking mechanism to prevent unintentional retraction. Safety note: the retraction spring has high tensile forces. When operating the roller blind, make sure that nobody is near the lower tube. If the retraction spring needs to be replaced, make sure that the retaining screw for the spring is screwed in before you pull out the old spring.

6) Colors
Special net available in green, blue, beige, gray, brown and black at no extra charge

The width of the door must be cut to the opening width on site, a remnant can remain wound on the upper tube to compensate for the height.

Width: 3.5 m
Height: 2.1 m
Weight: 47 kg